Negative Rig specific LL with DNO

Canela (6507/7-16 S) – P&A

What happened:

During M/U of 20″x36″ cutting assembly (MOST tool), had to break off MOST tool above space out pup to be able to MU space out to knife assembly. RE-MU space out pup below MOST tool. This was done due to IRN not able to grab connection between space out pup and knife assembly.

---

What was planned:

MOST tool

---

What was learned:

Space out pup between MOST tool and 20″x30″ knife assembly too short to use IRN.

---

What actions are required:

If space out pup between MOST tool and 20″x30″ knife assembly had been 20 cm longer, one could use the IRN.